The following example is for use on a Humax 5400
and we will use a Polsat channel in this example.
Once you have unzipped Wallbangor and started it
you will be confronted with the following main screen.
Select Nagra from the four options in the Mode box on
the right hand side above the four icons.

Below are the correct settings for use on a Humax 5400
To change any of the settings just click on the Settings Button (in the main screen)
while in Irdeto mode,you will then get access to the settings window
(com port settings may vary depending on your computers requirements)

If your using Wallbangor with a Joker Cam the settings are simular
with the exception of the ATR & Baud Rates which should be set to
4800 on each account, to do this set the ATR & BAUD Rate options
to 'Custom' then in at the bottom of the screen set both the
ATR & Baud Rate windows to 4800 (see screen shot below) then save
the changes you have made. Conax is not accessible.

To access the Keys in Nagravision all you do is
click the Yellow Key Icon, a window will then
appear with the following Providers (for Keys Click Below)
1 Polsat 13E     
2 StarDigi 42E
3 CaboTV 30W
4 ViaDigi 30W
Select the provider you wish to update by highlighting
it and then you can overwrite the key that needs updating
In our example it is Polsat Key 01 we will concentrate on.
See screen shot below

If you have followed the above and included the active Keys required
by Polsat, you can now click the 'Connect' button and you should receive
Polsat without any problem, remember that you must manualy add new keys
You will get confirmation that all is okay by
the following message on the main window
Gone Polsat 13E followed by the current Key
If you get the message Gone Fishing
then the keys require updating.

To update any nagra channel the procedure is exactly the same
but dont forget to select the Provider you wish to update.

All the best 'Laurals'

If you encounter this error message do the following:
Unable to open comport (win error code 5)
Press (Ctl Alt & Delete) then select "Processes"
on the tab then select Wallbangor.exe and
Click "End Process" that will close the Programme
and free the com port, you can now run Wallbangor,
if you do not have Wallbangor running, then select
the programme that is currently using the specified
com port and close it, by clicking "End Process"
this will then free the com port and you can now run
the Wallbangor programme without any problems.

All the above have been tried and tested using Wallbangor and a Humax 5400 (ToH 3.1 & 3.2)

Our thanks to Rob for creating Wallbangor for us.

Click Here for additional Help